- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Not able to creat DHCP pool
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Team i am not able to cretae DHCP POOL, i have already created few but suddenly its started giving error.
Error:-
Error! Failed to create DHCP Pool
Firmware Version | 11.0.0.18 | |||||||
Boot Version | B1.0.0.5 | |||||||
CPLD Version | 0x5 | |||||||
Serial Number | 4641535500023 | |||||||
AC | Operational |
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Eric
Thank you for the reply, we found that the switch has the limitation of 16 DHCP pool and we already utilized those limits that’s why it’s giving error.
Thank you once again.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Not able to creat DHCP pool
Hi @rajivsingh
Welcome to Community!
Could you please share the configuration that you set for DHCP pool? By CLI command or Web GUI? And also pelase screenshot the error message that swtich popup. It's will be helpful to debug this problem.
Regards,
Eric
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Eric
Thank you for the reply, we found that the switch has the limitation of 16 DHCP pool and we already utilized those limits that’s why it’s giving error.
Thank you once again.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Not able to creat DHCP pool
Hi @rajivsingh
Corret, this switch only can support 16 DHCP Pool totally. So it's expected behavior that switch popup error message once you config DHCP Pool more than the maximum value.
Regards,
Eric