Nighthawk R8000 WR cannot log into router over wifi.
Having this issue on two devices since I updated the firmware 1/12/2021: Windows 10 desktop and LG 8x Android cell phone.
Both are telling me that I am not connected to the router wifi. As I am connected to the R8000 wifi and have access to the internet.
I cannot ping 192.168.1.1 or access using routerlogin.net. I've reset the router, holding the reset button for 7 seconds and did the hold the reset button for 30 seconds, turn off the unit holding the reser button 30 seconds, and power the unit back up holding the reset button for 30 seconds. Nothing worked.
All my home devices are connected and worling. Just no access to the router.
I did just remove McAfee Virus software from my desktop but it wasn;t on my cell phone.
Re: Nighthawk R8000 WR cannot log into router over wifi.
I did not write down the firmware version. It's an Arris DG3270 from WOW.
What I don't understand is that it does not recognize that I am on the Nighthawk wireless routers WIFI. Keeps asking me to connect to the routers WIFI???????
2. put the netgears IP address into the arris's DMZ
3. Put the netgear in AP (access point) mode. This disables the routing functions and leaves the arris in control of those. You can either disable the wireless on the arris to reduce interference or just ensure its on a seperate channel from the netgear.
it could be why you can't access the router at the defaults ip address, it might have changed when it detected another router on the network/using that ip address.
Easy check. disconnect the netgear from the arris and reboot the netgear. Then connect a pc/laptop to it and open a command prompt. Type ipconfig. The default gateway is going to be the netgears IP address.
