R700

[Mariocarr]

Il router si resetta e non ci si collega con la wifi

[FURRYe38]

In inglese per favore

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

What channels are you using? Auto? Try Auto and 48 on 5Ghz. Or try setting manual channel 1, 6 or 11 on 2.4Ghz and 40 to 48 channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?

[Mariocarr]

The actual firmware is 11.023

I use channels 5 and 2,4 in auto mode

I have not other connection near to me.

I traied to reset the appliance but now only the first led is on and all the other are off.

[FURRYe38]

What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

[Mariocarr]

My internet server provide is Vodafone. I have disconnected the R7000 from router, but the problem it's the same

[FURRYe38]

If your having same problems on the ISP wifi router, then you'll need to contact the ISP for help and information regarding there services. 

This would be a double NAT condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the NG router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the NG router gets from the modem. https://kb.netgear.com/25891/DMZ-on-NETGEAR-routers
https://kb.netgear.com/24086/How-do-I-set-up-a-default-DMZ-server-on-my-Nighthawk-router
3. Or disable all wifi radios on the modem and connect the NG router to the modem, LAN to LAN configure AP mode on the NG router.
https://kb.netgear.com/24104/How-do-I-change-my-Nighthawk-router-to-AP-mode-after-I-ve-already-run-s...

[michaelkenward]

---

@Mariocarr wrote:

The actual firmware is 11.023

---

That's not a Netgear firmware number.

The version on my R7000P, as listed in your first footer, is V1.3.3.142_10.1.75.

For the R7000 it is 1.0.11.134.

[Mariocarr]

My firmware is: V1.0.11.126_10.2.112
But if I serch a new version, it doesn’t exists

[michaelkenward]

---

@Mariocarr wrote:
But if I serch a new version, it doesn’t exists

---

Search how?

If you own the R7000 rather than the R7000P – we still don't know – then you are four versions, and six months, behind the latest.

Visit the support pages:

Support | NETGEAR

Feed in your model number and check the documentation for your hardware.

That page will also have any software, firmware and drivers for your device, if they exist.