R8000p QoS not showing up

[alaknkstiyo]

Hi

I've just upgraded from a x4 to a x6s, recently configured from scrath but I seem to be unable to find QoS and to be able to see which device is using all my bandwidth, do you guys know how to enable it? or does the x6s does not have it? I kind of remember that but not so sure.

Thanks in advance.

[ElaineM · Accepted solution]

Per engineering, QoS will be available in the fourth quarter.

[ElaineM]

Welcome to the community, @alaknkstiyo

When you access admin page of the router, don't you see it under Advanced and then LAN Setup.

Under LAN Setup, you should be able to see QoS. I believe the router is using Dynamic QoS.

How do I enable Dynamic QoS on my Nighthawk router?

[alaknkstiyo]

Hi Elaine 

Thanks for replying, no QoS is shown even in advanced setup, I cannot even se the bandwidth usage when checking attached devices.

[alaknkstiyo]

[ElaineM]

Thank you for the screenshots. Let me check this with our engineering team and get back to you as soon as I have an answer.

[alaknkstiyo]

I did a bit of research and seems WMM is QoS but it won't let me control the priority level of any device plus won't show the bandwidth used by any of them like in the old R7500

[ElaineM · Accepted solution]

Per engineering, QoS will be available in the fourth quarter.

[alaknkstiyo]

Thanks a lot, I've accepted that as a solution

[ElaineM]

Thank you and have a great day!

[windsaga]

R8000P v1.2.1.6 do support Dynamic QoS.