- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Is it possible to enable telnet or ssh on a MS510TX ?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just purchased a MS510TX with the intent of using either telnet or ssh (preferably ssh) to configure it. I've done this with Prosafe switches and thought the MS510TX would be perfect for this but sadly I cannot find a way to enable telnet or ssh. Any help appreciated.
thanks
trent
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The shell access isn't intendend for production CLI access, and in no aspect supported.
As usual, you can enable "Remote Diagnostics" via "Maintenance>Troubleshooting>Remote DIagnostics"
Then telnet the manage ip address via port 60000
Works on the MS510TXUP for example, too
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The shell access isn't intendend for production CLI access, and in no aspect supported.
As usual, you can enable "Remote Diagnostics" via "Maintenance>Troubleshooting>Remote DIagnostics"
Then telnet the manage ip address via port 60000
Works on the MS510TXUP for example, too
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Is it possible to enable telnet or ssh on a MS510TX ?
Thank you, very helfpfull!