Could you post the Beta 6.9.1-T119 firmware for the ARM processor based systems like RN214?

[Miklos]

Dear Skywalker,

Could you post the ARM version of the 6.9.1-T119 beta firmware which has corrected the bonding issue - the whole package not just the hotfix...

"Re: Keep getting NETWORK CHANGED message since upgrading to 6.9.0

Thanks for the detailed information.  We are now able to duplicate the issue using a Nighthawk S8000 switch.  After updating the firmware to the version I mentioned earlier, the problem went away.  You can now download 6.9.1-T119 here, and it should resolve the issue.  Please confirm if it works for you."

The above link is just for the x86_64 version models...

Thanks in advance,

Miklos.

[Miklos]

Thanks for the detailed information.  We are now able to duplicate the issue using a Nighthawk S8000 switch.  After updating the firmware to the version I mentioned earlier, the problem went away.  You can now download 6.9.1-T119 here, and it should resolve the issue.  Please confirm if it works for you."

The above link is just for the x86_64 version models...

[Skywalker · Accepted solution]

We have located an issue with bonded network interfaces on RN2xx systems.  It should be resolved in 6.9.1 Beta 1, which is now available.

[kohdee]

Hi @Miklos

The fix that is in 6.9.1-T119 is only applicable for x86 units.  If you're having similar symptoms, it is unrelated to the problem in x86 units. 

There is a 6.9.1 beta coming within the next week or so that you can check out and see if you still have a similar issue, but would need to be diagnosed separately than the x86 units.

[Skywalker · Accepted solution]

We have located an issue with bonded network interfaces on RN2xx systems.  It should be resolved in 6.9.1 Beta 1, which is now available.

[Miklos]

Great job Skywalker!

I will test it right away! 🙂

[Miklos]

Well done - after the firmware upgrade to 6.9.1-T127 Beta 1 the error gone! 😄

[Skywalker]

Great!  Thanks for the confirmation.