- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: RND2110 V1 - can be seen and logged into, no shares seen
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I had this as a previous topic, but lost the link for a few days, and when I found it again, it was locked.
Below is the original post and response. Since then I have found the Nas is an RND2110 V1, if it helps.
+++
I have a 12 year old ReadyNas duo I would like to get working, I have put in a single 1TB WD Blue and done a factory reset just to be sure. I can see it in the Virgin Hub 3.0 I have, and have gotten the IP address from there.
Issues are:
1. Raidar does not recognise it in a scan
2. IP address allows login from a browser, but does not show any shares or errors
3. Sometimes I can see it in explorer, but cannot access there (error 0x800004002: no such interface supported).
I have activated the Windows SMB, and also enabled Netbios over TCP/IPv4 in the WiFi adapter.
+++
Here is what I see when I log into the IP address:
The following shares are accessible using this browser. Click on the icon to access the share. |
Then nothing to select....
Any thoughts?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you want to access the web admin ui, you need to browse to http://nas-ip-address/admin
If you leave the admin bit off, you end up looking at a share list. This will only show shares that have http enabled as a sharing protocol, so after a factory reset it will be empty.
Have you tried using \\nas-ip-address in file explorer (not clicking on the NAS in the network list)? Be careful to use the backslash, as the forward slash will open your browser.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
Aha, the Raidar 4.3.8 seems to see it, then I guess I need to setup from there?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
If you plan to do a Factory reset yes you will use RAIDar to set it up. What is the status showing on RAIDar? Can you try accessing the NAS on Windows Explorer using the IP? Also, toggling the services you enabled and rebooting the PC might help.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
Yup, already did a factory reset, as I thought that best since it sat for so long.
IP shows just what I pasted above, then nothing.
I guess I will search for a link on setup unless anyone has a link to hand...
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you want to access the web admin ui, you need to browse to http://nas-ip-address/admin
If you leave the admin bit off, you end up looking at a share list. This will only show shares that have http enabled as a sharing protocol, so after a factory reset it will be empty.
Have you tried using \\nas-ip-address in file explorer (not clicking on the NAS in the network list)? Be careful to use the backslash, as the forward slash will open your browser.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
Thanks
Leaving off shares does no good, it just forwards me back to shares.
looking at the IP in explorer works, but just shows me a blank window.
Should I follow my old paper manual and do a setup from the old Raidar?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
Tried IP and admin in browser:
Attackers might be trying to steal your information from 192.168.0.27 (for example, passwords, messages or credit cards). Learn more
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
ah, I'm in.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
Thanks, Will do the setup wizard!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
argh, I've removed the bittorent, thinking this would just disable it, but its gone from the setup now!
Anyway to get it back later?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
@hamslice wrote:
argh, I've removed the bittorent, thinking this would just disable it, but its gone from the setup now!
Anyway to get it back later?
Yes, you can download it from here: https://kb.netgear.com/24546/Add-ons-for-RAIDiator-4-1-3-Sparc Then install it as an addon.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: RND2110 V1 - can be seen and logged into, no shares seen
Thanks Stephen, will delete other topic, was just trying to finish up!