Netgear WNDR3400 V2 dashboard

[barsim2]

Hello,

Unable to get into my rourter dashbord because some time ago i changed the manufacturer credentials (admin and password) to something different that i didn't keep.

Is there any way to overcome this quandary?

Thank you

[michaelkenward · Accepted solution]

---

@barsim2 wrote:

.... some time ago i changed the manufacturer credentials (admin and password) to something different that i didn't keep.

---

The only thing that you could change would have been the password. The "admin" bit is fixed.

[plemans]

Not sure if password recovery works on that old of a device but you can try. 

https://kb.netgear.com/24220/How-do-I-recover-my-NETGEAR-admin-password-using-the-password-recovery-...

If not, you can always factory reset it to get back to the defaults and then just reinstall it

[michaelkenward · Accepted solution]

---

@barsim2 wrote:

.... some time ago i changed the manufacturer credentials (admin and password) to something different that i didn't keep.

---

The only thing that you could change would have been the password. The "admin" bit is fixed.

[wcalifas]

You can always do a hard reset and it will go back to factory default and you'll have to do your settings over again that you might have had saved already.