Introducing the Orbi 970 Series Mesh System with WiFi 7 technology. For more information visit the NETGEAR Press Room.
This topic has been closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
Start a New Discussion
I want to set one of the 5 ports e.g. 0/6 to different fixed link speeds for testing auto detection of connected devices.
The switch has an internal UART connection accepting CLI commands.
What is the full command to set port 0/6 to e.g. 100Mb, full duplex | half duplex?
I tried following: interface ethernet 0/6 speed 100M duplex-full, and variants of that command, but it always returns an error message
Even if there is kind of a CLI - it's neither tested, workable, nor supported or documented in any aspect.
