- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Firmware upgrade, now showing do_exit+8ec error
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Hopefully someone can help me with this.
I logged into the admin page of the ReadyNAS tonight and it was telling me an update was availible, i think i was on 6.4.2 and 6.6.0 was availible, not thinking much of it i clicked to update the firmware. After 15mins a little while i checked the NAS again to see what its status was, i could not access the web admin page so i checked the NAS itself and the screen was showing a message "do_exit+8ec". I left it a while longer to see if its status would change but it did not. I pulled the power from the NAS box and turned it back on but unfortuantly its showing the same message with no access to its admin page.
Any ideas or suggestions to resolve this?
Thanks
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After remotely fixing some problems it appears to have now booted fine on 6.6.1 Beta 2.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
I have sent you a PM.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
Hello,
I have the same problem
how do i fixed this
Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
Try USB Boot Recovery with 6.6.1 Beta. Let us know how you get on with this.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After remotely fixing some problems it appears to have now booted fine on 6.6.1 Beta 2.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
Hi.
I am getting the message do_exit+8ec after I updated the RN104's admin page.
Have tried USB boot with all the softwares using the USB repair tool without any solution.
Would appreciae any help in the matter.
Thanks and Rgds
Sunil
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
What is a "PM"
Where can I get the Firmware 6.6.1 Beta 2 version ?
Rgds
Sunil
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
See https://community.netgear.com/t5/ReadyNAS-Beta-Release/ReadyNASOS-6-6-1-T220-Beta-3/td-p/1172692
We're up to Beta 3 now.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Firmware upgrade, now showing do_exit+8ec error
@sunil1968 wrote:
What is a "PM"
"Private Message"
There's a Message link at the top right of the forum pages. You can also set the notifications in your profile so you receive an email whenever a message is received.