- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
ReadyNAS 214 not able to access Admin page and power light flashing
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ReadyNAS 214 not able to access Admin page and power light flashing
My ReadyNAS 214 will not allow me to login to the Admin page and the power light keeps blinking. When I try to access the admin page, it asks for ID and Password, but when I key them in it shows "Connecting to the ReadyNAS Admin Page..." and will eventualy time out. I am able to access the file shares and PlexServer without a problem. It will not reboot via the power button so I have done a hard power off and on with the same results. It looks like it is booting up most of the way except for the admin console. I am running 6.10.3 firmware. Not sure what else to try.
Thanks,
Karl
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS 214 not able to access Admin page and power light flashing
Update, I downloaded and ran RAIDar and it is able to find and connect to the ReadyNAS. It shows status as "Management service is offline". I was not able to run Diagnostics as it states "Failed to get diagnostics message" I was able to download the logs. I have looked through them and did not see anythng standing out, but I am not sure what I should be looking for either.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: ReadyNAS 214 not able to access Admin page and power light flashing
Hi Belgarid,
Can you send the logs to me? We will check what caused the issue. You may upload it to a file-sharing site then send the download link via private message.
Regards,