- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Upgrading one of HDD to 4TB drive
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Upgrading one of HDD to 4TB drive
Hi,
I was running 2x2TB JBOD formatted disks configuration in ReadyNAS Duo V2. I upgraded one of the disks to 4TB, but ReadyNAS created only 2TB volume.So, total capacity remained the same 4TB, I expected it to be 6TB. What can I do to use extra 2TB from my new HDD?
RND2000-200EUS
RAIDiator 5.3.13
HDDs:
WDC WD20EARS-00MVWB0 1863 GB
ST4000DM004-2CV104 3726 GB
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgrading one of HDD to 4TB drive
Do you only have a single C volume, or do you have both a C and a D volume?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgrading one of HDD to 4TB drive
I have both C and D. Both of them are displayed as 1.81TB
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgrading one of HDD to 4TB drive
I don't own the v2, so I don't have direct experience with it.
You could try creating the volume again. If that gives the same result, you might need to do a factory reset.
Are you familiar with the linux CLI? If ssh is enabled, you could use the linux command line to expand the file system on the volume.