Forum Discussion

Tutor

Mar 29, 2018

Solved

IP Address Conflict between Routing Interface and Interface vlan

Hello,

we are using a management vlan for our switch einvironment. Therefore we configure the specified vlan interface with the appropriate ip address. Furthermore we set the management vlan interface on the same ip address.

If the switch is booting the log file is showing the following entry:

IP Address Conflict between Routing Interface and Interface vlan xxx.

Do we misunderstand these two parameters? Must both ip addresses are different?

Thanks,

Clemens

Troubleshooting

ClemensD
Jun 12, 2018
Hello,

the final update, i guess.

after some time of researching Netgear has been solved my issue with firmware 12.0.4.10.

It will we available for download soon.

Best,

Clemens

6 Replies

ClemensD
Tutor
Mar 29, 2018
Netgear Support contacted.

Thanks, Clemens
- DaneA
  NETGEAR Employee Retired
  Apr 01, 2018
  Hi ClemensD,
  
  Welcome to the community! :)
  
  I found out that you have already opened a support ticket with NETGEAR Support and still ongoing. You may share here in the community about the progress of your online support ticket.
  
  Regards,
  
  DaneA
  
  NETGEAR Community Team
  - ClemensD
    Tutor
    Apr 03, 2018
    Hi DaneA,
    
    if i have further information about the result i will post it here. Actually the Netgear support cannot reproduce the issue. This may caused of different steps during the initial setup via ezsetup.
    Normally we use configuration templates für each specific switch device type.
    
    Best,
    Clemens