NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
POST Issues GSM4248UX
Hi, the power on start of self teset on my
GSM4248UX is failing. I power on the switch and it starts with the test. All of the ports in the back of the unit light up for a few seconds. The power LED blinks a number of times then stays on red solid light. The switch is not accessible via the OBB or any of the ports.
The switch was working fine for a day or tow, but then we updated the software to the latest firmware. V13.0.5.24
Then we started having this issue.
I have tried the paper clip reset multiple times, but there are no indications that this is working at all.
Any comments will be greatly appreciated.
2 Replies
Start by connecting the console, power on the switch and check the output...
What makes you believe it's a POST issue?
I tend to state the switch does not boot due to an unknown reason, for example because the installed image does not load?
The switch was working fine for a day or tow, but then we updated the software to the latest firmware. V13.0.5.24
Then we started having this issue.Keep in mind that firmware updates, setting the new image to active, and finally starting these switches takes reasonably more time than e.g. a simple Netgear Easy Smart or Plus Switch, which can come up on a fraction of a second.
Is this a very new switch these days for you?
Don't hesitate to contact Netgear Support in case for assistance. Be prepared to provide insight what the switch console output does show.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
