ReadyNAS Pro: System temp running out of spec

What firmware are you running?

Wow that was fast ;-)

I'm running V4.2.13-T10.

What firmware release before that, and was it okay then?

After having a look at the logs i can tell that the first message "running out of spec" arised while using 4.2.12-T30.

One additional info (don't know if it helps): 15 Minutes ago i opened the case directly after shutdown and the cpu cooler seemed to be rather cold (didn't measure it but comparing it to body temparture i would assume it was around 35 degree) although frontview reported about 61 degree before shutdown?! May there be a contact issue between cpu and cooler? Already checked the screws of the cooler but all are fixed as they should...

With the side panel off, is the CPU fan a 4-wire plug going to the mainboard, or a 3-wire plug going to the daughter board near the back? http://www.readynas.com/?p=1912

Already checked it, it's a 4-wire one connected to the main pcb.

Please send in your system logs (link in my sig).

Thanks for help! Logs sent...

chirpa he probably has the same issue as i did on my pro. reverting to 4.2.11 should instantly fix that. newer firmwares report cpu temp 5 degrees too high which generates these warnings.