WAC510 LAN Port in non-router mode

[BDubUT]

I've got a WAC510 on order and had a question about the "LAN" port on the AP.

I understand this specific AP can run in router mode, in which case the LAN port is self explanatory. Is it still available to use as a bridged port when the AP is running as a bridge? Or can it be used to create a LAG to the AP?

Thanks in advance.

[RaghuHR · Accepted solution]

Hi @BDubUT

To answer your question - No, We do not support LAG on WAC510.

When the AP is in bridge you can use LAN port to extend your network. 

Refer page #13

http://www.downloads.netgear.com/files/GDC/WAC510/WAC510_UM_EN.pdf?_ga=2.114256449.754014605.1528690...

Thanks,

Raghu 

[RaghuHR · Accepted solution]

Hi @BDubUT

To answer your question - No, We do not support LAG on WAC510.

When the AP is in bridge you can use LAN port to extend your network. 

Refer page #13

http://www.downloads.netgear.com/files/GDC/WAC510/WAC510_UM_EN.pdf?_ga=2.114256449.754014605.1528690...

Thanks,

Raghu