- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: WAX630 Unable to apply RF settings
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
WAX630 Unable to apply RF settings
Hello everyone,
At our company we use 8 WAX630 AP's (firmware 10.4.0.5, installed on March 21), managed through InSight. The AP's are all connected via 2 x MS510TXUP's.
Since (about) 3 weeks we receive alert mails from InSight (1 - 10 times a day), with the subject:
NETGEAR Account Alert:Device Command Failure
This happens throughout the whole day, with different AP's.
In the emails we see this alert:
Device Name: rdngap0001
Network Name: Reshift HQ
Serial Number: 6LD21851A0445
Model: WAX630
Failure Reason: Unable to apply RF settings for device rdngap0001.
When we receive this alert, most of the times, the devices connected with this AP are disconnected.
Does anyone know a solution for this?
Kind regards,
Martijn Broeders
Reshift Digital B.V.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAX630 Unable to apply RF settings
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAX630 Unable to apply RF settings
@LegcyLegend11 wrote:
Was a solution ever found? I am having the same issue.
Does "same issue" apply to a WAX630 (as per the subject), or the WAX610Y (tagged using the associated product selection)?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAX630 Unable to apply RF settings
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: WAX630 Unable to apply RF settings
Has there been a solution for this issue? I am facing this with WAX610 and WAX630 regularly.
Running the latest formware.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content