- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: View active connections
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone, how do I see all the active connections on my router ??
FVS318N
Thank you Emy
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To check what the devices that are currently connected via LAN and wireless, access the web-GUI of the FVS318N then go to Network Configuration > LAN Setup > LAN Groups. Kindly read pages 68-72 of the FVS318N reference manual here.
Regards,
DaneA
NETGEAR Community Team
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
Hi Emy,
Welcome to the community!
On FVS318N,can see active users under Monitoring->Active Users,VPN connection status under "VPN->Connection Status".
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
For VPNs and Active user (Which have logon access to the router) .... and for local connections LAN and WiFi?
Thank
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
Thank youuu.
Emiliano
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
Hi, just another doubt ... on this page I see ARP Table, but I do not see the active links at that time! If I rename "unknown" in the name of the connected device "Smartphone" (for example), this always stays in the table even when not connected!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
Firmware Version 4.3.5-3
Attached the screenshot....
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
Hello, news?
Thank
Emiliano
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
HI Emy
Please note that the arp table has some caching so if the device has been seen previously in the network could take a few minutes to disappear.
However if you edit the name and save the binding this will be kept in the table even if it's not connected. The prupose of this bindings is not to change the name is to set up a binding between MAC and IP so you can add firewalls rules to avoid any IP or MAC violation.
Hope it helps
Xavier Lleixa
NETGEAR CBU PLM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: View active connections
Hi, I know the ARP TABLE functionally, I thought that in this form you could see connected devices even if renamed ... if instead this mask is ARP Table then obviously the operation is correct.
Thank you
Emiliano