M4100 - IP subnet and routing

[Luda24]

My LAN is in 10.11.12.x

Now I like to make a IP-subnet with 192.168.16.x on Port 2.

This works 🙂 , but how I configure a route from the WLAN to the LAN ?

Thanks .

[Luda24]

My LAN is in 10.11.12.x

Now I like to make a IP-subnet with 192.168.16.x on Port 2.

This works 🙂 , but how I configure a route from the WLAN to the LAN ?

Thanks .

[JohnC_V]

Hi Luda24,

Welcome to our community! 🙂

In order for us to assist you better with the issue, kindly provide us additional information.

- May I know what do you want to achieve here?

- Do you want to create static routes from the WLAN to your LAN?

- Are there any VLANs in your network?

How do I add a static route using the web interface on my managed switch?

I'm looking forward to your reply.

Regards,

JohnCarloV

NETGEAR Community Team

[Luda24]

I like to create a subnet for the WLAN. I have no VLAN.

The WLAN needs access to the Servers, Printers and Internet.

The Subnet works, is i define a Port-IP-Adress.

But I can not route in the higher net. (Using Servers, Internet).

Thanks for help.

[schumaku]

Not sure what the purpose should be ... no VLAN, but two different IP subnetworks .. I`m a little bit confused. If you want to establish a transparent connection for a VLAN SSID to the wired subnet - so same security zone, same security level, ... what's the point of this design?