Reply

New Firmware v2.3.2.120 (XR450)

Netduma_Alex
NetDuma Partner

New Firmware v2.3.2.120 (XR450)

Hi all,

 

Thanks for your patience, we’ve got a new firmware for you to test.

 

Highlights of this update:

  • Big improvements to IPv6 compatibility
  • Improvements to general stability
  • System-wide GUI improvements
  • Updates to game and device detection
  • Fixed DHCP renewal causing internet to drop

 

I would highly recommend you do a factory reset after upgrading for the freshest installation.

 

Firmware: https://www.dropbox.com/s/p0ohpkiz45dpt2g/XR450-V2.3.2.120.zip?dl=0

Message 1 of 54
FURRYe38
Guru

Re: New Firmware v2.3.2.120 (XR450)

Thank you. Will get it loaded and start testing. Smiley Wink

My Setup (Cable 1Gbps/50Mbps)>CM1200 v2.02.03(LAG Disabled)>RBK853 v3.2.18.1/RBK50 v2.7.2.104(WW)
Additional NG HW: C7800/CM1100/CAX80/CM2000, Orbi CBK40, R7800, R7960P, EX7500/EX7700, XR450(v2.3.2.120) and WNHDE111
Message 2 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)

I dont think congestion control is working with ipv6 on

Message 3 of 54
Netduma-Liam
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

How have you come across this? What differences are you seeing that suggests IPv6 is causing an issue with QoS?

Message 4 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)

I was testing ping with cmd and it shoots up to like 300 while under load with ipv6 on with it off it still shoots up but not as bad like 80 some

Message 5 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

What QoS settings were you using while doing this test?
Message 6 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)

Qos was on always i even put the sliders at like 50 percent also the speed test on the router give me A+ on the first 2 and a D on the  ping under load test

Message 7 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

Did you do a factory reset after you upgraded the firmware?
Message 8 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)


@Netduma-Fraser wrote:
Did you do a factory reset after you upgraded the firmware?

yes

Message 9 of 54
Netduma-Liam
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

How did you perform the factory reset, through the interface or via the pin on the back of the router?

Message 10 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)


@Netduma-Liam wrote:

How did you perform the factory reset, through the interface or via the pin on the back of the router?


Both i did interface first on old build and pin on new build

Message 11 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

Could you try factory resetting from routerlogin.net/adv_index.htm please as I'm not sure the other methods are resetting correctly, then try please.
Message 12 of 54
hell12309
Apprentice

Re: New Firmware v2.3.2.120 (XR450)

what are the new features on this build id like to know

Model: XR500|Nighthawk Pro Gaming Router
Message 13 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

@hell12309 there are no new features over the other beta builds, just what is mentioned on the first post.
Message 14 of 54
hell12309
Apprentice

Re: New Firmware v2.3.2.120 (XR450)

i found an issue with the xr450 beta update it tries to connect but it immediately disconnects the wifi on some devices so i had to downgrade to the non beta update

Model: XR500|Nighthawk Pro Gaming Router
Message 15 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

Did you do a factory reset after upgrading? If not I would highly suggest doing so as it prevents issues carrying over
Message 16 of 54
hell12309
Apprentice

Re: New Firmware v2.3.2.120 (XR450)

Ohh ok I keep forgetting but the last update I. Never had that issue
Model: XR500|Nighthawk Pro Gaming Router
Message 17 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

It won't always happen but depending on what gets changed between the versions, old level code from a previous version can cause issues. Re-upgrade then factory reset and see if you get the same issue please.
Message 18 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)


@Netduma-Fraser wrote:
Could you try factory resetting from routerlogin.net/adv_index.htm please as I'm not sure the other methods are resetting correctly, then try please.

I tried that same issue

Message 19 of 54
hell12309
Apprentice

Re: New Firmware v2.3.2.120 (XR450)

It worked over here
Model: XR500|Nighthawk Pro Gaming Router
Message 20 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

Okay thank you both, this is something we'll really need to try and reproduce ourselves, will get back to you if I get a good workaround.
Message 21 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)


@Netduma-Fraser wrote:
Okay thank you both, this is something we'll really need to try and reproduce ourselves, will get back to you if I get a good workaround.

i meant i was still having the ping under load issue still

Message 22 of 54
Netduma-Fraser
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

@dewayne221 oh I see, did the factory reset using that page wipe everything successfully for you then?
Message 23 of 54
dewayne221
Aspirant

Re: New Firmware v2.3.2.120 (XR450)


@Netduma-Fraser wrote:
@dewayne221oh I see, did the factory reset using that page wipe everything successfully for you then?

mostly i think my internet speeds stayed

Message 24 of 54
Netduma-Liam
NetDuma Partner

Re: New Firmware v2.3.2.120 (XR450)

Where did you see that they remained the same? Did you not set this when going through the initial setup?

Message 25 of 54
Discussion stats
  • 53 replies
  • 2725 views
  • 3 kudos
  • 10 in conversation
Announcements