- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Short Netgear GS110TPv3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Short Netgear GS110TPv3
i have connected a CC Camera to port g2, but i see message Short. i am very new to Manage Switches, and i don't understand this.. What does below mean? does it mean cable is faulty at 90-100 meter distance. ?
thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Short Netgear GS110TPv3
Thank you for your response,
But when i have tested with cable tester, the cable is good. i getting response on 8 wires in my Cat6 cable. does it still have fault?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Short Netgear GS110TPv3
The cable test - not to compare with a top of the line RF pulse and reflectometer tester - requires standard compliant cables, and fully terminated end. What is shown there as a short could be caused by certain Fast Ethernet devices, with not full standards compliant random wire grounding at the other end for example.
Also keep in mind, these are smart switches, by far not fully managed switches.
If the camera works, does establish a Fast Ethernet or probably a Gigabit Ethernet link, forget about the cable test.