Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Browser not accessing ReadyNAS GUIs
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-02-08
04:36 AM
2022-02-08
04:36 AM
Browser not accessing ReadyNAS GUIs
Hi there, hoping someone has a solution to a fairly major issue accessing the U.I.s of my two old (but still going strong) ReadyNAS Duos. Since my Edge Browser has updated it refuses to access the IP address of either of my units. Downloaded Chrome to try that instead but no good either. Had a bit of a look around the Community for any other clues without luck. Any advice much appreciated!
Model: RND2000|ReadyNAS Duo Chassis only, RND2000v2|ReadyNAS Duo v2 Chassis only
Message 1 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-02-08
05:02 AM
2022-02-08
05:02 AM
Re: Browser not accessing ReadyNAS GUIs
Whoa, worked it out - Edge has an Internet Explorer mode so I can use that to access Frontview!
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2022-02-08
05:51 AM
2022-02-08
05:51 AM
Re: Browser not accessing ReadyNAS GUIs
@Tiltsinoz wrote:
Whoa, worked it out - Edge has an Internet Explorer mode so I can use that to access Frontview!
Great.
Double-check that you are running the most recent firmware:
- 4.1.16 for the original sparc-based duo (likely what you have, since you reference frontview).
- 5.3.13 for the v2
Message 3 of 3