- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Can't Access Boot Menu - Ultra 6
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I realize there are other threads about this issue but mine is a bit diiferent.
I just replaced memory in both my Ultra 6s. The steps were:
Ultra Unit A
Removed disks
Installed new memory
Ran memory test (passed)
Replaced disks
Done
Ultra Unit B
Removed Disks
Installed new memory
Couldn't access Boot Menu to perform a memory test.
Swapped memory from Unit A and Unit B (with "good" memory)
Couldn't access Boot Menu
Placed blank disk in Unit B and powered up.
Couldn't access Boot Menu
Disk Passed
Started to perform Factory Reset on Unit B
I pulled the plug when I saw "Awaiting RAIDar"
So it seems Unit B is working fine other than I can't access the Boot Menu.
I would imagine the reset button isn't functioning on Unit B or is it possibly caused by something else?
Here's my MAIN question:
What should I expect when I put the original disks in Unit B?
I noticed that Unit B was assigned a new IP address so I am somewhat uncertain about what to expect.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't Access Boot Menu - Ultra 6
Which firmware are you running on Unit B?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't Access Boot Menu - Ultra 6
Firmware on both units is 4.2.27.
Unit A is working just as it was before the memory upgrade.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Can't Access Boot Menu - Ultra 6
All is well with my Ultra 6. mdgm took a look at it and found no issues. Look like a faulty reset switch. Everything is working as it did before I started this thread.
I APPRECIATE mdgm's time and effort in looking into my issue.
Thanks, mdgm.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content