I have my Windows 7 PC connected direct to the NAS drive via Lan cable (from the laptop to the LAN2 connection) and when I open "My Computer" and then click on Network my Nasdrive shows up and i can access it
2. issues 1. File access and transfer via the above method is very slow. the folders and content take a very long time to load 2. When I use RAIDar i get a "RAIDar Help" page telling me that it cannot find the NASDrive on the network - The NAS drive is connected to my routed via powerline connections since my router is in a separate room to my office. the powerline plug shows all green so thatis connected fine - When i look at the connection at the back of the NAS there are two lights, the left is orange and the right flickers green If i swap the connections LAN1 and LAN2 between so that the PC is now connected to the LAN1, the powerline again shows an orange light to the left
So the issues i am having are: 1. Slow folder / file load 2. Cannot connect to RAIDar
currently doing a password reset because i've forgotten the password and i am waiting for the new password to come through. will let you know how i get on thanks
RAIDar requires broadcast packets to be carried by the network. Firewalls can interfere, and some connections (perhaps your powerline) filter them out.
You said you have a direct connect from the PC to the NAS; do you also have an internet connection to the PC? If so, the PC is "multihomed", which might also confuse RAIDar's scan.
Are you still seeing slow performance? How slow is it?
My laptop is connected to the router via wifi and to the nas via a LAN cable
Internet connection to the laptop is fine Internet Connection to the has appears to be fine because I can access and work with it through front view ..... I am currently doing a software upgrade of raidiator to 4.2.22 (via front view) ... But that has been running now for about 2 hours So, independently, internet wise they appear to be fine, but via raidar they jusy cannot see eachother
As for speed, it was in the region of 6 hours to copy about 3.5 Gb of data using drag/drop from within "my computer" over the LAN cable
Home internet connection speed is - download - 5.72 Mbps - upload - 0.77 Mbps
From your drag/drop test you are getting ~1.5 mbps (~200 KBps) Powerline throughput is a bit hit-or-miss - it depends on circuit loads, wiring, etc. It could actually be running that slow, even though it is green. Like wireless, link speeds are always a lot higher than throughput. Do you know if your gadgets have built-in powerline filters? That can make a big difference.
Your internet connection speed would only be a factor if you were using ReadyNAS remote. Even then it is supposed to negotiate a peer-to-peer connection.
Personally I'd connect the NAS to the router directly if possible [avoiding powerline]. Could you try that as a test?
right, i've connected my laptop direct to the same router the ReadyNAS is connected to and then ran RAIDar, but it still doesn't work, RAIDar is not finding the NAS drive
