- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Blocking IP range/subnet with ACL
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can only assume I'm missing something here... I want to block access to one VLAN from another whilst maintaining routing via the switch. Simple enough on the face of it.
I have set an IP ACL bound to the VLAN in question to block IP traffic to 192.168.0.0 255.255.255.0 but it does nothing. If I set the IP to 192.168.0.10 255.255.255.0 then I cannot ping the device on that IP, so the rest of my config should be fine.
Am I doing something wrong, or is this just not supported on this switch?
Firmware is updated to 6.3.1.11
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Blocking IP range/subnet with ACL
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Blocking IP range/subnet with ACL
Hi RussU,
You're welcome! 🙂 I am glad that it helped you.
Feel free to post your future concerns here in the community.
Regards,
DaneA
NETGEAR Community Team